We are into the part of fighting against global warming. We recieved the projects from ola electric technologies private limited
The Complete Engineering & Design for the proposed project is proposed to be carried out in sequential steps/ stages seeking approval of CLIENT at each level so as to make sure that the facility being designed is as per the User requirements.
HVAC & Clean Room
- Prepare concept note giving details of the entire system and design HVAC/Clean room system complying with requirements and consisting of following activities
- Room data sheet giving dimensional details of room, temperature and humidity requirements, equipment heat load, occupancy, cleanliness classification and required minimum air change rate.
- Air handling zoning strategy.
- Room design criteria with headloads.
- Preliminary requirement of chilled water, steam, hot water, electric heaters
Piping
- Overview/summary of utility load requirements including peak flow, daily flow, spare capacity for future, minimum operating pressure etc for all utilities required in the plant.
- Design parameters for each utility system.
- Preparation of Preliminary Flow Diagrams for each utility.
- Preliminary Pipe rack routing for major Pipe rack.
- Basis of Design documents for Mechanical piping and Insulation Work. Clean Utilities Generation & Distribution System
- Design parameters for treatment, generation and distribution of various types of clean utilities (as applicable).
- Capacity calculation for various clean utility generation system (as applicable).
Electrical
- Preliminary load estimate.
- Single line diagram indicating the number of panels and distribution boards.
- Preliminary power distribution strategy.
- Requirement of emergency power and UPS.
- Lighting strategy – internal and external.
- Design, Engineering of complete electrical distribution in the plant from a single HT source, including
- Prepare Single line diagrams, power, earthing, and lightning protection layout, cable schedules, cable tray layout.
- System requirements and schematic drawings for Emergency power supply, UPS system & telephone and LAN system.
- Design the lighting system for the complete plant.
- MTO and specifications for motors, light fittings, cables, low voltage and high voltage panels, push button stations, socket outlets, substation equipment, etc.
- Review and approve vendor drawings for transformers, diesel generator sets, distribution and control panels, lighting distribution boards, motors, cables, variable frequency drives, UPS, etc.
- Design lightening protection system.
- Prepare tender specifications for electrical Installation work laying down the methods of erection, testing, start-up, etc,
- Verification & approval of data/ layout prepared & submitted by contractor.
×